Call if you have any questions about this. If not, a high to low-level adapter must be used in conjunction with this part. Be sure to verify that your amplifier has this feature. Most all modern amplifiers for use with motorcycle applications are designed to accept speaker-level input at the RCAs. This unit outputs a speaker-level audio signal with an RCA-type connector. It Will Not work with the factory amplifier(s). Note: This unit is intended to be used with aftermarket amplifiers only. Ultra models require our radio T harness to aquire rear radio signal. Compatible Model - Street Glide, Road Glide, Electra Glide.This plug however is dead (no signal) unless the radio is programmed for 4 channel output using a flash tool. Rear Channel Tech InfoĪll two-channel bikes (90% of all bikes sold) have a rear speaker output connector located behind the factory radio. Rear kits do however come with an adapter that makes them compatible with the rear radio outputs. Speaker pod connectors are only used for front fairing applications. Note: If you are purchasing this item for rear signal only you will not need the optional speaker pod connectors and they will not be in your kit. Optionally we offer a rear signal version that plugs in and converts this adapter to fit the 4 pin connector that Harley uses for the rear channels on 4 channel bikes. This kit comes ready to plug directly into the front signal harness of the factory radio on all Harley touring bikes. We always recommend using speaker pod connectors along with our signal adapters. This way you can connect your aftermarket amplifier directly into your fairing speaker pods without any cutting or splicing into the bike's wire harnesses. This kit also comes with connectors that mate to your fairing speaker pods. It also enables rear speakers, front-to-back fader (not all flashes do), bass and treble controls, and speed-dependent volume feature. This particular flash has a friendly EQ curve for aftermarket amplifiers and speakers. These flashes are all supplied to them by a number of aftermarket amplifier manufactures, but we recommend using the one from Rockford Fosgate. Technoresearch has a number of flashes that its software offers. You can find our flash rental tools here. It is highly recommended that you either have your radio flashed by an independent bike shop with the proper equipment or rent a flash tool and flash your bike yourself. This is the simplest and best way to get a signal from your factory Harley radio when installing an aftermarket amplifier.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |